Clean Bond Technical Data

PERFORMANCE

Clean Bond is a powerhouse cleaner and adhesion promoter engineered to help remove debris and oil deposits faster with less work to increase adhesion when using the Pancrete Family of Products.

  • Molecular degreaser
  • Removes oil and oil vapor deposits
  • Simple and fast to use
  • Specially formulated bonding agent

CHARACTERISTICS

HMIS: 2-1-0
pH: Neutral
Green: Free of objectionable NPEs and APEs
Vapor Density (AIR=1): >4
Evaporation Rate (Water=1): <1
Solubility in Water: Emulsifies
%Volatile (by wgt): >70%

  • Appearance and Odor: Yellow Liquid. characteristic lemon odor.
  • Respiratory Protection: Non required while threshold limits are kept below maximum allowable concentrations; if TWA exceeds limits NIOSH approved respirator must be worn.
  • Ventilation: The use of local exhaust ventilation is recommended to control emissions near the source. Provide mechanical ventilation in confirmed space.
  • Eye Protection: Chemical splash goggles.
  • Protective Gloves: Neoprene, butyl or nitrile rubber gloves with cuffs.
  • See Material Safety Data Sheet for more detailed information.

APPLICATION

Clean Bond application is a 2-step process: The cleaning step and the bonding step.

Cleaning Step:

  1. Prepare surfaces as normal by removing loose or flaked rust and other debris.
  2. Mix Clean Bond at a 1 :9 ratio with water (one quart of Clean Bond to 9 quarts water).
  3. Spray mixture onto surfaces.
  4. Scrub the surfaces using a clean broom or scrub brush with a long handle to remove oils and disperse and remove small particles left from the initial cleaning. This cleaning step prepares the way for the next step.
  5. Rinse thoroughly to flush lifted oils and particles down the drain, and then wet-vac to remove pools of water that may remain.

Bonding Step:

  1. Apply concentrated Clean Bond to the surfaces to be coated with ta pump-up sprayer. The concentrate delivers a laboratory developed bonding agent that moleculary bonds to the metal and has great affinity for the Pancrete.

    2. This helps insure the utmost in bonding strength.

  2. One gallon covers about 400 square feet. Damp surfaces are what you are after. Spraying is quick and easy.
  3. Rinse the surface after 10 to 15 minutes and wet-vac or let dry. Then apply Pancrete as recommended.

  • share